Fast Installation and Configuration
With its above-ground installation, the Leddar d-tec system is a non-intrusive solution designed to be rapidly and seamlessly integrated with current traffic infrastructure, without the need to install additional mounting poles. Its on-board camera also enables quick remote configuration.
It only takes a few hours to install a complete intersection (2-4 hours for a typical setup) and as little as 15 minutes to configure. The onboard camera allows the Leddar d-tec to easily be configured remotely. The video feed, transmitted back to the Traffic Operations Center (TOC), enables rapid alignment with desired detection areas and also simplifies maintenance operations.
To learn more about LiDAR fundamentals, visit Why liDAR.
Built to Last
Thanks to its robust solid-state design with no moving parts, the solid-state LiDAR sensor used by the d-tec provides high reliability and reduced maintenance costs compared with mechanical scanning LiDARs. Housed in a resistant casing delivering IP67 Ingress protection, these LiDAR sensors are built for year-round operation over a very wide range of temperatures.